For dog owners who are still hesitant in buying an in-ground dog proof fencing because of the method of burying the wires, Above Ground Installation method can be applied. This technique can be done with the use of our Securing Staples. With these sturdy staples, dog owners can now just lay the wires above the ground. This procedure is not dangerous because eventually the wires will be covered by grass after a good rain.

Above Ground Installation is perfect for those who are just renting their homes or don’t have any tools for digging. Or if dog owners simply don’t like the idea of burying the wires, using staples will answer the problems in securing the wires for underground electronic dog proof fencing.

 

Step 1:

» First lay out the boundary wire in the desired shape and around the area dog owners want to contain. From the boundary wire run twisted wire to the transmitter and pug it in.
» Once dog owners have decide the system dog owners chose is correct for dog owners, "Staple" the twisted wire to the ground by hammering in a wire "Staple" every 5 - 6 feet.
» Now stop and look at the wire. Is it completely flush to the ground all the way to the start of the boundary? The wire MUST completely touch the ground. If not go and "Staple" any raised areas before proceeding to the next step.

Step 2:

» Place a "Staple" where the twisted wire and the beginning of the boundary meet (if dog owners have a splice in this area please dig a small hole about 2 inches deep and bury the splice. Then place a "Staple" in the front of and behind the splice to relieve any pressure on the splice)
» Next, walk to the first corner of the boundary and "Staple" it to the ground. Repeat this step for all corners of the boundary. (Not all yards are square if dog owners do not have corners on the boundary please select multiple anchor points for the wire)
» Now place staples as needed and make sure to staple any raised areas down until they are completely flush with the ground, for maximum safety for dog owners and the guests.